---
title: "Centrifugal Pump Bearings: Selection and Arrangement"
date: 2026-11-09
description: "Centrifugal pumps combine radial load from the impeller with axial thrust from the pressure difference across the impeller. This guide explains the standard bea..."
source: https://en.mshjzc.com/bearing-engineering-applications/58165.html
---

# Centrifugal Pump Bearings: Selection and Arrangement

Centrifugal pumps combine radial load from the impeller with axial thrust from the pressure difference across the impeller. This guide explains the standard bearing arrangement and how to select the right bearings for pump service.

See also [bearing arrangement](/bearing-selection-guide/58141.html) and [angular contact bearings](/bearing-basics/58128.html).

## What Loads Does a Pump Bearing See?

- **Radial load** - from impeller weight, pipe strain and hydraulic radial force
- **Axial thrust** - from pressure difference between front and back of the impeller, always toward the suction side

A single deep groove ball bearing cannot handle both reliably. Pumps use a pair arrangement.

## Standard Bearing Arrangement

Most overhung centrifugal pumps use:

- **Inboard bearing (near impeller)** - angular contact ball bearing, takes axial thrust
- **Outboard bearing (near coupling)** - deep groove ball bearing, takes radial load, floats axially

The angular contact pair is often mounted back-to-back (DB) to provide rigidity. In heavy-duty process pumps, two angular contact bearings are paired at the inboard end.

## Split Case Pumps

Between-bearing split case pumps use two radial bearings (usually deep groove or cylindrical) on either side of the impeller. The axial thrust is balanced by opposed impeller eyes or a balance drum.

## Common Pump Bearing Problems

- **Pipe strain** - misaligned piping pulls the pump casing, overloading the bearings
- **Cavitation** - causes shock loads that spall the raceways
- **Lack of oil** - ring-oiled or sump-lubricated pumps run dry if oil level is wrong
- **Shaft misalignment** - coupling misalignment doubles bearing load

## Lubrication

Small pumps use grease. API process pumps use oil sump or oil circulation, often with a constant-level oiler. The oil level must sit at the center of the lowest rolling element.

## Frequently Asked Questions

### Why do pump bearings fail after coupling alignment?

Misalignment creates a huge alternating load on the outboard bearing. Check alignment with a laser before blaming the bearing.

### What does a cavitating pump bearing look like?

The raceway shows pitting and spalling concentrated on one side, with a characteristic frosted appearance. The impeller also shows erosion.

### Can I use a sealed bearing in a process pump?

API pumps usually use open bearings with housing oil lubrication. Sealed bearings are fine for small ANSI pumps, but check the speed and temperature limits.

## Related Reading

- [Bearing Arrangement](/bearing-selection-guide/58141.html)
- [Angular Contact Bearings](/bearing-basics/58128.html)
- [Contamination Wear](/bearing-installation-failure/58153.html)

## Need Pump Bearings?

MS Bearing supplies angular contact and deep groove bearings for ANSI and API process pumps. Send us your pump model or bearing numbers, and we will confirm replacements with the correct preload and clearance.
