---
title: "Static Load Safety Factor S0: Avoiding Brinelling Under Shock Loads"
date: 2026-11-09
description: "Dynamic load rating C and L10 life tell you about fatigue under rotating load. But when a bearing sits still, carries heavy shock, or supports a stalled load, t..."
source: https://en.mshjzc.com/bearing-selection-guide/58184.html
---

# Static Load Safety Factor S0: Avoiding Brinelling Under Shock Loads

Dynamic load rating C and L10 life tell you about fatigue under rotating load. But when a bearing sits still, carries heavy shock, or supports a stalled load, the limiting factor is permanent deformation—brinelling. The static safety factor S0 controls this.

## What Is S0?

The static safety factor is: **S0 = C0 / P0**, where C0 is the basic static load rating from the catalog and P0 is the equivalent static load (the heaviest combined radial+axial load the bearing sees at rest or under shock). If S0 falls below a recommended value, the rolling elements press into the raceways and create permanent indentations.

## Recommended S0 Values

<table border="1" cellpadding="6" cellspacing="0" style="border-collapse:collapse;width:100%;"><tr style="background:#f0f0f0;"><th>Application</th><th>Minimum S0</th></tr><tr><td>Smooth operation, no shock</td><td>0.5–1</td></tr><tr><td>Moderate shock, normal industry</td><td>1–1.5</td></tr><tr><td>Heavy shock, impact load</td><td>1.5–2</td></tr><tr><td>High reliability required, crane hook, swivel</td><td>2–3</td></tr><tr><td>Severe shock, reciprocating compressors, crushers</td><td>3–4</td></tr></table>

## Why Shock Matters

A stationary bearing under repeated shock load (such as a crane lowering a load, a rail car passing over a joint) experiences peak P0 far above the running load. The peaks create brinelling even if average load is low. S0 must be checked at peak shock, not at running load.

## Relation to False Brinelling

True brinelling is permanent plastic deformation from overload. [False brinelling](/bearing-installation-failure/58155.html) is fretting damage from small oscillatory motion under load. Both look like indentations but have different causes. S0 protects against true brinelling; false brinelling is prevented by lubrication and by eliminating micro-motion.

## Choosing C0

When sizing bearings for oscillating, slow or heavy-lift duty, calculate S0 before checking L10. A larger bearing with higher C0 may be needed even if L10 life is already long. Thrust bearings, crane hooks and turntables are typical cases where S0 governs.

## FAQ

**Q: Is a higher S0 always better?**  
A: Up to a point. Very high S0 means over-sized bearing, higher cost and heavier sections. Match S0 to the application severity.

**Q: Does S0 apply to rotating bearings?**  
A: It applies to the heaviest load the bearing sees, including stalled or shock peaks, even in rotating equipment.

## Related Reading

- [Dynamic vs Static Load Rating: C and C0 Explained](/bearing-selection-guide/58136.html)
- [Equivalent Dynamic Load: X and Y Factors](/bearing-selection-guide/58144.html)
- [False Brinelling and Fretting](/bearing-installation-failure/58155.html)

*Sizing a bearing for shock or hoist duty? [Send us your peak static load](/contact-us.html)—we will recommend a C0 that meets S0 targets.*
