Needle roller bearings use long, thin rollers (needles) with a diameter-to-length ratio of 1:3 to 1:10. Despite their slim cross-section, they carry surprisingly high radial load - the price is reduced speed capability and no axial load capacity. They are the solution when radial space is restricted but load demand is high.
Compare with cylindrical roller bearings and other bearing families.
Why Needle Rollers?
Standard cylindrical roller bearings have relatively short rollers. Needle roller bearings pack many long, thin rollers into the same radial space. Because line contact is spread over a long line, the unit pressure on the raceway is low. A needle roller bearing of 50 mm OD can often carry the same radial load as a deep groove ball bearing of 80 mm OD - saving 30 mm of radial space.
This makes them indispensable in gearboxes, automatic transmissions, connecting rods and small universal joints where every millimeter counts.
Drawn Cup vs Machined Rings
Drawn Cup Needle Roller Bearings (HK / BK Series)
The outer ring is a thin sheet-metal cup deep-drawn from steel strip. It is very thin and light, press-fits into the housing, and costs less than a machined ring. HK is open on one side; BK has a closed end that seals the bearing and provides a stop.
Machined Ring Needle Bearings (NA / RNA Series)
Both inner and outer rings are machined from hardened steel bar. They are more rigid, more precise, and can be removed and reused. NA has a machined inner ring; RNA uses the shaft itself as the raceway (the shaft must be hardened to HRC 60).
Caged vs Full Complement
Caged (Standard)
A cage spaces the needles, allowing higher speed and less friction. This is the default choice for rotating applications.
Full Complement (No Cage)
Maximum number of needles packed into the ring. Higher load capacity but lower speed due to needle-to-needle friction. Used for very slow, heavy load applications such as rock crusher eccentrics.
Typical Applications
- Automotive gearboxes and transmissions (connecting rods, rocker arms)
- Universal joints and cardan shafts
- Compressor and piston pins
- Small gearbox layshafts
- Two-stroke crankshafts
- Clutch release assemblies
Frequently Asked Questions
Can a needle roller bearing carry axial load?
Standard needle rollers cannot carry axial load at all. For combined load, use needle roller and cage assemblies combined with angular contact ball bearings, or combined needle bearing units.
Does the shaft need to be hardened for an RNA bearing?
Yes. When the inner ring is omitted (RNA series), the shaft itself is the raceway. It must be hardened to at least HRC 60, ground to the correct tolerance, and have sufficient surface finish.
What is the difference between HK and BK?
HK is an open drawn cup (open at both ends). BK has a closed bottom on one side, acting as an end cap and axial stop. BK bearings are common in gearbox layshafts where the cup closes one end.
Related Reading
- What Is a Rolling Bearing?
- Cylindrical Roller Bearings: N/NU/NJ/NUP Series
- Needle Roller Combination Bearings
Need Needle Roller Bearings?
MS Bearing supplies HK, BK, NA and RNA drawn-cup and machined-ring needle bearings, plus needle roller and cage assemblies. All units are CE certified and dimensionally interchangeable. Send us your OD and bore, and we will confirm availability and factory pricing.
