sales@cnprv.com

+86 15862366271 (WhatsApp/WeChat)

Bearing Failure: Fatigue Spalling and Raceway Damage

MS Bearing WareHouse

When a bearing reaches end of life, it fails in a predictable pattern. Reading the failed raceway tells you whether the bearing simply lived its design life, or whether something went wrong during installation, lubrication or operation. This guide covers normal fatigue spalling and how to distinguish it from premature failure.

See also other failure modes.

What Is Fatigue Spalling?

Every rolling cycle subjects the raceway to a contact stress pulse. After millions of cycles, tiny cracks form below the surface, propagate to the surface, and material flakes off. This is spalling - the normal end-of-life failure mode predicted by the L10 life formula.

Spalling appears as rough, matte patches on the raceway where material has flaked out. The bearing starts making noise and vibrating, but can often run for hours or days before complete failure.

Where Spalling Tells the Story

The location of spalling points to the root cause:

  • Spalling on both rings and all rolling elements - normal fatigue, bearing reached its calculated life
  • Spalling only on one side of the raceway - misalignment, shaft bent, housing bore not straight
  • Spalling concentrated at one position around the ring - outer ring turned in housing, or outer ring rotating with inner ring fixed
  • Spalling on the rolling ends only - excessive axial load or misalignment

How Long Should a Bearing Last?

If a bearing is properly sized, installed and lubricated, it should reach or exceed its calculated L10 life. If it fails much earlier, investigate the four causes:

  1. Contamination (dirt, water, dust)
  2. Lubrication failure (wrong grease, overheat, no relubrication)
  3. Improper installation (brinelling during mounting)
  4. Wrong sizing (overloaded, too much preload)

Visual Diagnosis Quick Reference

What You SeeWhat It Means
Even spalling across racewayNormal fatigue, correct life
Brushed, polished racewayContamination, abrasive wear
Dark blue/brown discolorationOverheating, lubricant failure
Indentations at ball spacingBrinelling from shock or vibration
Grooved, worn cage pocketsLubrication failure or skidding

Frequently Asked Questions

How long should a motor bearing last?

Standard industrial electric motor bearings should last 40,000 to 80,000 hours. If they fail before 20,000 hours, investigate lubrication, alignment and contamination.

Can I run a spalled bearing temporarily?

Yes for short periods, but vibration will increase and the spall will grow quickly. Plan a replacement during the next maintenance window. Ignore it and the bearing will seize.

What does normal wear look like?

A light, uniform polishing of the raceway and rolling elements is normal. The raceway should still be smooth to the touch. Rough, pitted or grooved surfaces indicate abnormal wear.

Related Reading

Need Replacement Bearings?

MS Bearing supplies direct replacements for all standard bearing types. Send us the failed bearing number or the machine model, and we will confirm the correct replacement and factory-direct pricing within 24 hours.