Spherical roller bearings, self-aligning ball bearings and some cylindrical roller bearings are available with a tapered bore (1:12, suffix K). They mount on a metric stepped shaft either with an adapter sleeve or a withdrawal sleeve. The two methods look similar but work differently.
Adapter Sleeve (H Series)
An adapter sleeve is a slotted bushing with an external thread on one side and a lock nut. You slide it into the tapered bore of the bearing, then tighten the lock nut. As the nut pushes the sleeve through the bearing, the slotted bushing compresses onto the shaft. Adapter sleeves work on both stepped and plain shafts and are the most common method. The bearing sits between a locating washer and the lock nut.
Withdrawal Sleeve (OH Series)
A withdrawal sleeve is also slotted, but it is used when the bearing sits against a shaft shoulder. You draw the sleeve into the bearing using a lock nut on the side opposite the shoulder. The bearing is then located between the shoulder and the sleeve. Withdrawal sleeves are used on large bearings and where dismounting requires pulling the sleeve off, not pushing the bearing over a shoulder.
Mounting Steps
- Clean shaft and sleeve; lubricate the sleeve threads and mating surface.
- Slide the sleeve into the tapered bore.
- Hand-tighten the lock nut until all clearance is gone.
- Tighten further by the recommended amount to reduce clearance (usually by measuring radial clearance drop).
- Lock the nut with a locking tab or pin.
For hydraulic mounting, use a hydraulic nut and oil injection to seat large bearings. See bearing installation methods.
When to Use Which
Use adapter sleeves when the bearing is in the middle of a shaft and there is no shoulder on the side of the lock nut. Use withdrawal sleeves when a shaft shoulder locates the bearing and the lock nut pulls the sleeve against the shoulder. For plummer blocks, adapter sleeves are standard.
FAQ
Q: Can I mount a K bearing directly on a metric shaft?
A: No. The 1:12 tapered bore needs a sleeve to reduce onto a cylindrical metric shaft. Without a sleeve it will not center or grip.
Q: How tight should the lock nut be?
A: Tighten until the measured radial clearance drops by the amount given in the catalog, not by feel. Use a feeler gauge or dial indicator.
Related Reading
- Bearing Installation: Cold, Hot and Hydraulic Methods
- Spherical Roller Bearings
- Self-Aligning Ball Bearings
Need adapter or withdrawal sleeves for a K-bearing application? Send us bearing bore and shaft size—we supply matched H and OH sleeve kits with lock nuts.
