sales@cnprv.com

+86 15862366271 (WhatsApp/WeChat)

Conveyor Roller Bearings: Idler Sealed Units for Bulk Handling

MS Bearing WareHouse

Conveyor idlers are the most numerous bearings on any bulk material handling site. There are thousands of them on a single belt conveyor, and they must run for years with no maintenance. This guide explains how idler bearings are designed.

See also deep groove bearings.

What Is a Conveyor Idler?

A conveyor idler is a steel tube mounted on a stationary axle, supported by two bearings pressed into the ends of the tube. The belt rolls over the top. The bearings are deep groove ball bearings pre-greased and sealed for life.

A typical 1200 mm belt conveyor has hundreds of idlers spaced every meter. They run at slow speed (under 300 rpm) but must survive dust, moisture and weather.

Idler Bearing Design

An idler bearing is not just a 6204 bearing. The housing is a pressed steel cup that holds a standard deep groove bearing. The seal system is critical:

  • Rubber contact seal on the bearing itself (2RS)
  • Additional felt or labyrinth seal in the end cap
  • Grease packed in the cavity between bearing and seal

This triple seal arrangement keeps coal dust, ore dust and water out for 50,000 hours or more.

Typical Idler Bearing Sizes

  • Light duty (small belts) - 6204, 6205 deep groove
  • Medium duty - 6305, 6306
  • Heavy duty (large belts) - 6308, 6309

Most idlers use C3 clearance and NBR contact seals.

Why Idler Bearings Fail

  • Water washout after rain - seals broken
  • Dust ingress through damaged seals
  • Static load brinelling when the belt is parked with material on it
  • Out-of-balance rollers causing vibration and false brinelling

Frequently Asked Questions

How long should idler bearings last?

Good quality idlers last 50,000 to 80,000 hours. Cheap idlers fail in 5,000 to 10,000 hours from poor seals. The idler replacement cost over a mine's life dwarfs the upfront price difference.

Can I relubricate idler bearings?

Most modern idlers are sealed and cannot be relubricated. Some heavy-duty idlers have a grease zerk, but relubricating thousands of idlers is impractical. Choose sealed units and replace them when they fail.

What does a bad idler sound like?

A rhythmic clunk or rattle as the belt passes over it. Walk the conveyor and listen. Bad idlers damage the belt and add drag.

Related Reading

Need Conveyor Idler Bearings?

MS Bearing supplies deep groove bearings for conveyor idlers with heavy-duty triple seal arrangements and long-life lithium grease. Send us your idler specifications, and we will confirm the correct bearing and price.