Cold-pressing a bearing onto a shaft risks scratching the journal and misaligning the ring. An induction bearing heater expands the inner ring in minutes so it slides on freely. It is the standard mounting tool for any bearing above about 20 mm bore.
How It Works
An alternating magnetic field induces eddy currents in the inner ring, heating it evenly. A thermocouple on the ring controls temperature. The inner ring expands thermally while the shaft stays cool, giving a clearance fit during mounting.
Correct Temperature
Heat to 80–110°C above ambient, never above 120°C. Above 120°C, the bearing steel begins to temper and hardness drops, permanently reducing fatigue life. For bearings with nylon cages, check cage temperature limits—some cages cannot exceed 80°C.
Mounting Sequence
- Clean the shaft and mark the target position.
- Place the bearing on the heater yoke with the bore vertical.
- Heat to 90–100°C. Typical cycle is 5–15 minutes depending on size.
- Wear heat-resistant gloves. Slide the bearing onto the shaft in one smooth motion.
- Hold it against the shoulder until it grips. Do not let it slide back as it cools.
Safety Tips
Do not heat the bearing above the recommended temperature. Do not leave the heater unattended. Keep the yoke clean and properly sized—too small a yoke wastes energy. For magnetized bearings, demagnetize after heating if the heater does not have a demag cycle.
When Not to Heat
Small bearings under 10 mm bore can be cold-mounted with a sleeve. Sealed bearings (2RS) should not be heated above 80°C because the grease and seals can be damaged. See installation methods.
FAQ
Q: How long does heating take?
A: A 6205 bearing heats in about 5 minutes; a 22220 spherical roller may take 15–20 minutes on a correctly sized heater.
Q: Can I reuse a heated bearing?
A: Yes, if it did not overheat and the seal/cage is intact.
Related Reading
Buying an induction heater? Tell us max bearing weight—we recommend the right yoke size.
