sales@cnprv.com

+86 15862366271 (WhatsApp/WeChat)

Brinelling vs False Brinelling: How to Tell the Difference

MS Bearing WareHouse

Both true brinelling and false brinelling leave evenly spaced indentations on the raceway. They look similar but have opposite causes. Mixing them up leads to the wrong repair. This guide shows how to tell them apart.

True Brinelling (Overload)

True brinelling happens when static or shock load exceeds the contact fatigue limit. The rolling elements press into the raceway and leave permanent indentations spaced exactly one rolling element diameter apart. The indentations are shiny, metal-displaced ridges, and they occur where the load was heaviest. See static safety factor S0.

False Brinelling (Fretting)

False brinelling happens when the bearing does not rotate, or oscillates through a very small angle. The rolling elements rock back and forth, squeezing out the lubricant. Metal-to-metal contact creates fretting wear and a rust-brown groove. The marks are evenly spaced but filled with fine wear particles. See false brinelling and fretting.

Comparison

FeatureTrue brinellingFalse brinelling
CauseOverload / shockMicro-motion, lost oil film
ColorShiny, displaced metalRust-brown, fine dust
ShapeIndentation ridgesWorn grooves
When it happensDuring load or impactDuring transport, standstill
FixUpsize bearing, raise S0Improve lubrication, eliminate micro-motion

FAQ

Q: Does false brinelling mean the bearing is bad?
A: Early false brinelling may still run if the grooves are shallow. Once rust pits connect, replace the bearing.

Q: How do I prevent it during transport?
A: Rotate shafts periodically or lock the rotor against oscillation. Fill bearings with fresh grease before shipping.

Related Reading

Analyzing raceway marks? Send us photos—we will help distinguish overload from fretting.