Lubrication is the single most important factor in bearing life. It separates the rolling elements from the raceways with a thin oil film, reduces friction, prevents corrosion and flushes away heat and contaminants. Choosing between grease and oil is the first decision engineers make. This guide compares the two approaches.
See also bearing seals and speed limits.
What Lubrication Actually Does
Under load, the rolling elements and raceways are separated by a microscopic oil film 0.1 to 1 micrometer thick. If this film is maintained, metal-to-metal contact never occurs and the bearing lasts its calculated L10 life. If the film breaks - from wrong viscosity, overheating, or contamination - the bearings fail within hours.
Grease Lubrication
Grease is oil thickened with soap (lithium, calcium, polyurea). It stays in the bearing, seals out contaminants, and requires almost no maintenance. About 90 percent of bearings are grease-lubricated.
Advantages
- Simpler housing design, no oil circulation system
- Good sealing against dust and moisture
- No oil leaks or oil level monitoring
- Pre-packed and sealed bearings are maintenance-free
Limitations
- Cannot remove heat from the bearing effectively
- Limited speed range compared to oil
- Grease degrades over time (typically 5,000 to 20,000 hours)
- Not suitable for very high temperature or extremely high speed
Oil Lubrication
Oil flows through the bearing, carrying heat away and flushing out wear particles. It is required for high speed, high temperature and heavy load applications.
Advantages
- Higher speed capability (up to twice grease limit)
- Heat removal allows continuous high-temperature operation
- Can filter and recirculate oil for long life
- Better contamination flushing
Limitations
- Requires oil sump, pump, filter and heat exchanger
- More complex seals and leak management
- Oil level must be monitored and changed periodically
- Higher initial cost and maintenance
Common Lubrication Systems
| Method | Use Case |
|---|---|
| Grease packed, sealed bearing | Motors, pumps, fans (most common) |
| Oil bath (splash) | Gearboxes, low-speed reducers |
| Oil circulation | High-speed gearboxes, compressors |
| Oil-air / oil mist | Machine tool spindles, very high speed |
| Jet lubrication | Gas turbine bearings, extremely high speed |
| Central grease system | Multiple points on conveyors and large machines |
How to Choose
Choose grease when:
- Speed is below the grease limit in the catalog
- Temperature is below 80 C continuously
- Simplicity and low maintenance are priorities
Choose oil when:
- Speed exceeds the grease limit
- Temperature exceeds 80 C and heat must be removed
- Load is very heavy or shock-heavy
- Contaminants must be flushed continuously
Frequently Asked Questions
Can I mix greases from different manufacturers?
No. Different soap thickeners (lithium, polyurea, calcium) can react and liquefy. If you must switch brands, flush the bearing completely and repack with the new grease.
How much grease should I pack into a bearing?
Fill the free space inside the bearing to about 30 percent for high-speed bearings, 60 to 80 percent for low-speed bearings. Over-packing causes churning and overheating.
Why is my grease turning brown?
Oxidation from heat or contamination. Grease that darkens, hardens or separates oil from soap has exceeded its service life and should be replaced.
Related Reading
Need Lubrication Advice?
MS Bearing supplies pre-greased sealed bearings and can recommend the correct grease or oil viscosity for your operating conditions. Send us your speed, temperature and environment, and our engineers will specify the lubricant and relubrication interval.
