Every bearing catalog lists two speed numbers: the reference speed and the thermal speed. Engineers often look at only one and are surprised when the bearing overheats. This guide explains what each speed limit means, why they differ, and how to select bearings that survive high-speed operation.
Pair with our guide to load rating and L10 life and fitting tolerances.
Reference Speed (Grease or Oil)
The reference speed is the speed at which a bearing can run under normal load with proper lubrication without exceeding a standard temperature rise. It is a mechanical limit based on the cage material, seal friction and centrifugal force on the rolling elements.
Reference speed is listed separately for grease lubrication and oil lubrication. Oil-lubricated bearings typically have a 20 to 40 percent higher reference speed because the oil carries heat away more effectively.
Thermal Speed
The thermal speed is the speed at which the heat generated by friction equals the heat the bearing can dissipate to the housing and shaft. Above this speed, temperature rises continuously until the lubricant fails.
Thermal speed is usually lower than reference speed for sealed or shielded bearings, because the contact seal adds frictional heat. For open bearings with good heat dissipation, thermal speed can be higher than reference speed.
Speed Reduction Factors
Catalog speed numbers assume a light load. In real applications, de-rate the speed when:
- Heavy load (P/C greater than 0.15) - reduce speed by 20 to 40 percent
- Sealed bearings (2RS) - reduce by 20 to 30 percent vs open
- High temperature (housing over 80 C) - reduce speed by 10 percent per 10 C above rating
- Poor heat dissipation (closed housing, no external cooling) - reduce by 20 percent
When to Choose Ball vs Roller for Speed
Ball bearings have a clear speed advantage over roller bearings because point contact generates less friction. For high-speed applications:
- Use deep groove ball bearings or angular contact ball bearings for high speed
- Use cylindrical roller bearings only when radial load is too high for ball bearings
- Avoid spherical roller bearings at high speed (heavy rollers, high centrifugal force)
- Thrust ball bearings have very low speed limits - use angular contact pairs for high-speed thrust
High-Speed Lubrication Options
For speeds above the standard grease limit:
- Oil bath - simple, limited to moderate speed
- Oil circulation - carries heat away, allows high speed
- Oil-air (mist) lubrication - tiny oil metered into air stream, used in machine tool spindles
- Jet oil lubrication - high-pressure oil injected directly into the contact zone, for very high speeds
Frequently Asked Questions
What happens if I run a bearing above its speed limit?
The cage fails first: centrifugal force distorts it, rollers skid, and heat rises rapidly. The lubricant breaks down, raceways overheat, and the bearing seizes. This happens within minutes, not hours.
Why is the thermal speed lower for sealed bearings?
The rubber contact seal generates friction heat at the inner ring land. This extra heat cannot escape easily, so the bearing reaches its thermal limit at a lower shaft speed.
Can I exceed the reference speed with oil cooling?
Sometimes. If the housing is externally cooled and oil is circulated, bearings can run above the catalog reference speed. The thermal speed number is the real limit in that case.
Related Reading
- Dynamic vs Static Load Rating
- Bearing Lubrication Guide
- Angular Contact Ball Bearings for High Speed
Need High-Speed Bearings?
MS Bearing supplies high-speed precision bearings with steel, brass and ceramic cages, suitable for motors, spindles and turbo machinery. Send us your target speed and load, and our engineers will confirm whether your application needs open, sealed, or oil-lubricated configuration.
