sales@cnprv.com

+86 15862366271 (WhatsApp/WeChat)

Bearing Internal Clearance: C2, C0, C3, C4 and C5 Selection

MS Bearing WareHouse
author admin 09 November, 2026

Internal clearance is the small amount of free movement between the inner ring, rolling elements and outer ring before the bearing is mounted. It is one of the most overlooked yet critical parameters in bearing selection. Choose the wrong clearance class, and a new bearing will run hot and fail within weeks. This guide explains the C2 to C5 scale and how to match it to your installation.

See also our guide to shaft and housing fitting tolerances and load rating C and C0.

What Is Internal Clearance?

When the bearing is on the shelf, you can feel a small slack: if you hold the outer ring and push the inner ring up and down, it moves by a few thousandths of a millimeter. That movement is the internal radial clearance. It ensures the rolling elements are not preloaded, allows thermal expansion, and provides room for lubricant film.

The Five Clearance Classes

CodeMeaningTypical Use
C2Less than normalHigh-precision, rigid arrangements, light interference fits
C0Normal (no suffix)General industrial, moderate fit, low temperature differential
C3Greater than normalElectric motors, pumps, hot-running applications (most common)
C4Even largerHeavy interference fits, high temperature rise, vibrating applications
C5LargestVery high temperature, heavy shock, vibrating screens

Why Interference Fit Reduces Clearance

When you press the inner ring onto a k6 or m6 shaft, the inner ring stretches slightly. That stretch narrows the internal clearance. A bearing that arrived as C3 on the shelf can end up as C0 once mounted on a tight shaft. For heavy interference fits on large bores, 20 to 40 percent of the original clearance is consumed by the stretch.

Why Temperature Differential Matters

In most motors, the inner ring runs 5 to 15 degrees hotter than the outer ring because heat is conducted through the shaft and housing at different rates. The hotter inner ring expands more, further reducing clearance. This is why motor bearings are almost always C3: they need extra clearance to survive the temperature rise during operation.

If the outer ring runs hotter than the inner ring (for example, in a heated roll), clearance actually increases, and C0 or C2 may be sufficient.

Typical Selection Rules

  • Electric motors, fans, pumps - C3
  • Machine tool spindles (preloaded) - C2 or special preload classes
  • Conveyor pulleys, vibrating screens - C4 or C5
  • Precision instrument bearings - C2
  • General gearboxes - C0 or C3 depending on fit

Frequently Asked Questions

What happens if clearance is too small?

The bearing runs hot. Rolling elements skid on the raceway, lubricant breaks down, and the bearing seizes within hours or days. This is the most common cause of premature motor bearing failure.

What happens if clearance is too large?

The shaft runs loose. Vibration and noise increase, gear meshing suffers, and the bearing experiences shock loads that shorten fatigue life. Large clearance also causes brinelling under static load.

Can I change clearance after mounting?

No. Internal clearance is set at the factory by grinding the raceways. Once mounted, the remaining clearance is fixed. If the wrong class was ordered, the bearing must be replaced.

Related Reading

Need Help Choosing Clearance?

MS Bearing stocks C0, C3 and C4 clearance classes in all common series. Send us your bearing number, shaft tolerance and expected operating temperature, and our engineers will recommend the correct clearance class for your application.