A bearing ring looks like a simple piece of steel, but the material and heat treatment determine whether it lasts 1,000 hours or 100,000 hours. This guide explains bearing steel grades, hardness ranges, and when to use stainless steel or ceramic rolling elements.
See also load rating basics and seal selection.
Standard Bearing Steel (52100 / GCr15)
About 90 percent of rolling bearings use high-carbon chromium steel AISI 52100 (called GCr15 in China, 100Cr6 in Europe). It contains about 1 percent carbon and 1.5 percent chromium, through-hardened to HRC 60-64 on the raceways.
This steel provides the high hardness needed for rolling contact fatigue. Raceways must be hard enough to resist brinelling from the rolling elements. The through-hardened structure also gives good dimensional stability at temperatures up to about 120 C.
Case-Hardened Steels
For bearings that see heavy shock loads, carburized steels (AISI 3315, 4320) are used. The surface is hardened to HRC 60 while the core remains tough and ductile. This prevents the ring from cracking under shock load. Common in automotive wheel bearings and heavy gearbox bearings.
Stainless Steel Bearings
For corrosive environments (food, chemical, marine), stainless steel grades are used:
- 440C (AISI 440C) - martensitic stainless, hardened to HRC 58-60, good corrosion resistance, lower load rating than 52100
- 304 / 316 stainless rings with 440C balls - non-magnetic, used in food and pharmaceutical equipment
Stainless bearings typically carry 20 to 30 percent less load than 52100 equivalents because of lower hardness.
Hybrid Ceramic Bearings
Hybrid bearings use steel rings (52100) with silicon nitride (Si3N4) ceramic balls. Ceramic balls are lighter, harder, and electrically insulating. They offer:
- Higher speed (up to 40 percent increase)
- Electrical insulation (prevents motor bearing damage from stray current)
- Longer grease life (lower friction)
- No rust on the balls
Hybrid bearings are standard in high-speed machine tool spindles and modern inverter-driven electric motors.
Hardness and Load Rating
The catalog dynamic load rating C assumes the raceways are hardened to HRC 58 or higher. If a bearing is run at high temperature (above 150 C), the steel softens and C must be de-rated. Special steels (M50, Cronidur 30) are used for high-temperature aerospace and turbine bearings.
Frequently Asked Questions
Why are bearing raceways so hard?
Rolling elements exert point or line contact pressures of up to 4,000 MPa. Soft steel would deform permanently. HRC 60 hardness is needed to resist plastic deformation and rolling contact fatigue.
Can I use a stainless bearing in a food plant?
Yes. 440C stainless rings with PTFE or stainless seals are common in food and washdown environments. The lubricant must also be food-grade (NSF H1).
What is a hybrid ceramic bearing?
It has steel rings and silicon nitride ceramic balls. The balls are lighter and non-conductive, making them ideal for high-speed spindles and electric motors prone to electrical pitting.
Related Reading
Need Special Material Bearings?
MS Bearing supplies standard 52100 chrome steel, 440C stainless, and hybrid ceramic ball bearings. Send us your corrosion, temperature or speed requirements, and we will recommend the correct material combination.
