sales@cnprv.com

+86 15862366271 (WhatsApp/WeChat)

Equivalent Dynamic Load: How X and Y Factors Work

MS Bearing WareHouse
author admin 09 November, 2026

The L10 life formula uses a single load number P, but real bearings carry both radial and axial loads. The equivalent dynamic load equation converts these combined loads into one number that predicts life. This guide explains the X and Y factors and how to apply them.

Start with C and C0 load ratings.

The Equivalent Load Equation

P = X * Fr + Y * Fa

Where:

  • P = equivalent dynamic load (kN)
  • Fr = applied radial load (kN)
  • Fa = applied axial load (kN)
  • X = radial load factor
  • Y = axial load factor

Once you calculate P, plug it into L10 = (C/P)^p to get bearing life.

How to Find X and Y

X and Y depend on the bearing type and the ratio Fa/C0. The catalog lists them in a small table. The process is:

  1. Calculate Fa/C0 from your actual axial load and the catalog static load rating C0.
  2. Look up the corresponding e value (a threshold ratio).
  3. If Fa/Fr is less than e, the bearing runs in "radial-dominated" mode: X = 1, Y = 0, so P = Fr.
  4. If Fa/Fr is greater than e, the bearing runs in "combined" mode: use the tabulated X (usually 0.56) and Y.

Worked Example: 6205 Bearing

A 6205 deep groove bearing has C = 14 kN, C0 = 7.8 kN. It carries Fr = 2.5 kN and Fa = 0.8 kN at 1500 rpm.

  1. Fa/C0 = 0.8 / 7.8 = 0.10
  2. From the table, e = 0.26 at Fa/C0 = 0.10.
  3. Fa/Fr = 0.8 / 2.5 = 0.32, which is greater than e = 0.26.
  4. So use X = 0.56 and Y = 1.71 (from the table).
  5. P = 0.56 * 2.5 + 1.71 * 0.8 = 1.40 + 1.37 = 2.77 kN.
  6. L10 = (14 / 2.77)^3 = 129 million revolutions = 1,433 hours.

If we had ignored axial load and used P = Fr = 2.5 kN, we would have overestimated life by about 25 percent.

Why the Threshold e Matters

The e value represents the contact angle transition. Below e, the bearing behaves like a pure radial bearing and axial load does not reduce life. Above e, the contact angle develops and axial load matters. This is why deep groove ball bearings can tolerate light axial load without life penalty.

Frequently Asked Questions

Do roller bearings also use X and Y?

Yes, but roller bearings have much lower Y values because they are not designed for axial load. Cylindrical roller bearings have Y = 0 (they cannot carry axial load at all).

What if Fa is zero?

If there is no axial load, P = Fr regardless of bearing type. The X and Y factors only matter when both loads exist.

Why is my calculated life shorter than expected?

Most engineers forget to include axial load. If Fa/Fr exceeds e, the Y factor multiplies the axial load and often dominates P. Always calculate both Fr and Fa.

Related Reading

Need Life Calculation Help?

MS Bearing engineers can calculate equivalent load and L10 life for your specific application. Send us Fr, Fa, speed and bearing number, and we will confirm whether your current bearing meets the design life target or needs upsizing.