A shaft almost always uses two bearings: one to fix the shaft axially, the other to allow thermal expansion. Getting this arrangement right is the difference between a machine that runs for years and one that binds, overheats or breaks. This guide covers the three classic bearing arrangements engineers use in rotating machinery.
See also angular contact bearing arrangements and fitting tolerances.
The Fixed-Floating Principle
Shafts grow longer when they heat up. A steel shaft that runs from 20 C to 80 C expands about 0.012 mm per meter of length. If both bearings lock the shaft axially, that expansion creates enormous compressive force that pushes the bearings off their seats. The solution is always the same:
- One fixed bearing - locates the shaft axially in both directions, supports radial load
- One floating bearing - supports radial load but slides freely in the housing or on the shaft
Fixed Bearing Options
Deep Groove Ball Bearing as Fixed
A single deep groove ball bearing can locate a shaft axially in both directions because it carries moderate thrust. The outer ring is clamped in the housing. This works for short shafts and light loads.
Angular Contact or Tapered Pair as Fixed
For heavy combined radial and axial load, use a pair of angular contact or tapered roller bearings mounted back-to-back (DB) or face-to-face (DF). The pair locates the shaft axially in both directions and provides rigidity. This is the standard for gearbox pinions and wheel hubs.
Floating Bearing Options
NU or N Cylindrical Roller Bearing
The inner ring and outer ring are completely separable. The shaft can slide axially relative to the outer ring. This is the most common floating bearing in gearboxes and large motors.
Deep Groove Ball Bearing with Loose Outer Ring
The outer ring is not clamped in the housing; it can slide axially in a straight bore. This is a simple floating arrangement for small motors and fans.
Self-Aligning Ball Bearing
The spherical outer raceway allows the inner ring to tilt, but axial sliding still requires a loose outer ring fit.
Back-to-Back vs Face-to-Face Pairs
Back-to-Back (DB / O arrangement)
The contact lines diverge outward. High moment stiffness, good misalignment resistance. Most common for fixed positions in gearboxes and pinions.
Face-to-Face (DF / X arrangement)
The contact lines converge inward. Easier to install, lower moment stiffness. Used where shaft deflection causes misalignment between bearings.
Tandem (DT)
Both bearings face the same direction. They share axial load in one direction. For bidirectional load, use at least three bearings. Common in very heavy thrust applications.
Typical Arrangements by Machine Type
- Electric motors - one fixed deep groove (drive end), one floating deep groove (fan end)
- Gearbox layshaft - one NUP fixed, one NU floating
- Centrifugal pump - one angular contact pair fixed, one deep groove floating
- Machine tool spindle - two angular contact pairs (one fixed front, one floating rear)
- Automotive wheel hub - two tapered roller bearings in X arrangement, preloaded
Frequently Asked Questions
What happens if both bearings are fixed?
The shaft cannot expand thermally. It grows, pushes the rings, and generates huge internal axial force. Bearings overheat, lubricant fails, and rings creep on their seats.
Can a single deep groove ball bearing be the fixed bearing?
Yes for light axial load. For heavy thrust, use an angular contact pair or add a separate thrust bearing.
Which is better, DB or DF?
DB (back-to-back) is stiffer and more common. DF (face-to-face) is easier to shim and tolerates slight misalignment better. Choose based on rigidity requirements and installation access.
Related Reading
Need Bearing Arrangement Advice?
MS Bearing engineers can help you select the correct fixed-floating arrangement for your shaft, based on load, speed, temperature and distance between bearings. Send us your shaft drawing or load data, and we will recommend the bearing types and arrangement.
