Both self-aligning ball bearings and spherical roller bearings accept shaft misalignment thanks to a spherical outer raceway. The difference is load capacity: ball vs roller. This guide helps you choose between them.
Misalignment Compensation
Self-aligning ball bearings have two rows of balls and a spherical outer ring raceway. They tolerate roughly 1–3 degrees of misalignment and are light, fast and quiet. They are ideal for long shafts, belt drives and fan rotors where alignment is imperfect but loads are moderate.
Spherical roller bearings have two rows of barrel-shaped rollers on a spherical raceway. They accept similar misalignment but carry much heavier radial loads and shock loads. They are the standard for mining, paper, cement and large fans.
Load Capacity
Spherical roller bearings have significantly higher dynamic load rating for the same bore size because rollers contact the raceway over a line, not a point. Self-aligning ball bearings are limited to light and moderate radial loads and cannot carry heavy axial load.
Speed and Friction
Self-aligning ball bearings run at higher speeds and lower friction, close to deep groove ball bearings. Spherical roller bearings run cooler in oil lubrication but at lower speeds, especially under heavy load.
Cost
Self-aligning ball bearings cost less than spherical roller bearings of the same bore. If load is light, do not over-specify spherical rollers. If load is heavy or shock exists, do not under-specify self-aligning balls.
Typical Applications
| Application | Best choice |
|---|---|
| Long fan shaft, belt idler | Self-aligning ball |
| Mining conveyor, vibrating screen | Spherical roller |
| Paper machine roll | Spherical roller |
| Light agricultural take-up | Self-aligning ball or insert unit |
| Crane sheave | Spherical roller |
FAQ
Q: Can I replace spherical roller with self-aligning ball?
A: Not if the original was spherical roller due to load. The ball bearing will be overloaded and spall quickly.
Q: Do both use adapter sleeves?
A: Yes. Both are available with tapered bore (K) for mounting on adapter or withdrawal sleeves.
Related Reading
- Self-Aligning Ball Bearings: When and Why to Use Them
- Spherical Roller Bearings: Self-Aligning Performance
- Mining and Heavy Industry Bearings
Need help choosing between these self-aligning types? Send us your load, speed and shaft alignment—we will recommend the correct series.
