sales@cnprv.com

+86 15862366271 (WhatsApp/WeChat)

Static Load Safety Factor S0: Avoiding Brinelling Under Shock Loads

MS Bearing WareHouse
author admin 09 November, 2026

Dynamic load rating C and L10 life tell you about fatigue under rotating load. But when a bearing sits still, carries heavy shock, or supports a stalled load, the limiting factor is permanent deformation—brinelling. The static safety factor S0 controls this.

What Is S0?

The static safety factor is: S0 = C0 / P0, where C0 is the basic static load rating from the catalog and P0 is the equivalent static load (the heaviest combined radial+axial load the bearing sees at rest or under shock). If S0 falls below a recommended value, the rolling elements press into the raceways and create permanent indentations.

Recommended S0 Values

ApplicationMinimum S0
Smooth operation, no shock0.5–1
Moderate shock, normal industry1–1.5
Heavy shock, impact load1.5–2
High reliability required, crane hook, swivel2–3
Severe shock, reciprocating compressors, crushers3–4

Why Shock Matters

A stationary bearing under repeated shock load (such as a crane lowering a load, a rail car passing over a joint) experiences peak P0 far above the running load. The peaks create brinelling even if average load is low. S0 must be checked at peak shock, not at running load.

Relation to False Brinelling

True brinelling is permanent plastic deformation from overload. False brinelling is fretting damage from small oscillatory motion under load. Both look like indentations but have different causes. S0 protects against true brinelling; false brinelling is prevented by lubrication and by eliminating micro-motion.

Choosing C0

When sizing bearings for oscillating, slow or heavy-lift duty, calculate S0 before checking L10. A larger bearing with higher C0 may be needed even if L10 life is already long. Thrust bearings, crane hooks and turntables are typical cases where S0 governs.

FAQ

Q: Is a higher S0 always better?
A: Up to a point. Very high S0 means over-sized bearing, higher cost and heavier sections. Match S0 to the application severity.

Q: Does S0 apply to rotating bearings?
A: It applies to the heaviest load the bearing sees, including stalled or shock peaks, even in rotating equipment.

Related Reading

Sizing a bearing for shock or hoist duty? Send us your peak static load—we will recommend a C0 that meets S0 targets.