sales@cnprv.com

+86 15862366271 (WhatsApp/WeChat)

Modified Rating Life: Reliability Factor a1 and aISO Explained

MS Bearing WareHouse
author admin 09 November, 2026

The basic L10 life calculation assumes 90% reliability, standard material, normal lubrication and clean operation. In real machines, lubrication, contamination and shock change the actual life. Modified rating life adjusts for these factors.

Reliability Factor a1

The basic L10 corresponds to 90% reliability. When the application requires higher reliability (for example, 95% or 99%), multiply life by the reliability factor a1:

Reliabilitya1
90% (L10)1.0
95%0.62
96%0.53
97%0.44
98%0.33
99%0.21

Lna = a1 × (C/P)p, where p = 3 for ball bearings and 10/3 for roller bearings.

Lubrication and Contamination Factor aISO

The more advanced ISO life method (ISO 281:2007) introduces the factor aISO, which accounts for:

  • Lubrication film thickness (viscosity ratio κ)
  • Contamination level (clean, light dust, heavy dust, water)
  • Fatigue load limit Cu

When the lubricant forms a full elastohydrodynamic film and the bearing is clean, aISO can extend life several times. Under contamination or poor lubrication, aISO falls below 1. See lubricant viscosity selection.

Why This Matters

Two identical bearings running the same load can deliver 50,000 hours in clean, well-lubricated service or 5,000 hours in dirty, starved service. The basic L10 ignores this. Engineers who need realistic life targets for critical machines use modified life, not just L10.

Practical Use

For general industry, L10 remains the standard contract and catalog calculation. For critical machines (main gearboxes, spindle bearings, conveyor pulleys in continuous process), apply a1 for required reliability and aISO for lubrication/contamination. Document the assumptions so procurement and maintenance share the same expectations.

FAQ

Q: Is L10 too pessimistic?
A: Often it is conservative because clean, well-lubricated bearings last longer. But in contaminated service it is optimistic. Modified life narrows the gap.

Q: What reliability does a 99% requirement need?
A: Multiply L10 by 0.21. You need to upsize the bearing by roughly (1/0.21)^(1/3) ≈ 1.7 times load rating to restore the same life.

Related Reading

Need a modified-life calculation for a critical machine? Share your load, speed and lubrication—we will run a1 and aISO for you.