sales@cnprv.com

+86 15862366271 (WhatsApp/WeChat)

Lubricant Viscosity: How to Choose the Right Oil Grade

MS Bearing WareHouse

Viscosity is the single most important property of a bearing lubricant. Too thin and the oil film collapses under load. Too thick and the bearing churns oil and overheats. This guide explains ISO viscosity grades and how to pick the right one for your bearing.

See also grease vs oil and speed limits.

ISO VG Viscosity Grades

Industrial oils are classified by ISO VG (Viscosity Grade). The number is the oil's kinematic viscosity at 40 C in mm2/s (cSt).

ISO VGViscosity at 40 CTypical Use
VG 2222 cStVery high speed, small bearings
VG 3232 cStHigh-speed electric motors, spindles
VG 4646 cStGeneral light industrial, pumps
VG 6868 cStGeneral industrial gearboxes, moderate speed
VG 100100 cStHeavy load, moderate speed
VG 150150 cStHeavy gearboxes, low speed
VG 220220 cStHeavy industrial, high temperature
VG 320 / 460320-460 cStExtreme load, very slow speed

Minimum Required Viscosity

For a bearing to maintain an elastohydrodynamic (EHL) oil film, the oil must have a certain minimum viscosity at operating temperature. This depends on bearing size and speed:

  • Small bearings, high speed - minimum 12 to 20 cSt at operating temperature
  • Medium bearings, moderate speed - minimum 20 to 30 cSt
  • Large bearings, heavy load - minimum 30 to 50 cSt

Because oil thins as it heats up, the operating viscosity is always lower than the 40 C catalog value. A VG 68 oil at 80 C may behave like a VG 22. If that drops below the minimum, the bearing runs in boundary lubrication and fails early.

Viscosity Index

The viscosity index (VI) measures how much the oil thins as temperature rises. Mineral oils typically have VI around 95. Synthetic oils (PAO, ester) have VI 140 or higher, meaning they stay viscous at high temperature. For machines that see wide temperature swings, choose high-VI synthetic oil.

How to Select

  1. Find the operating temperature of the inner ring (typically 10 to 20 C above housing temperature).
  2. Look up the oil's viscosity at that temperature from its temperature-viscosity chart.
  3. Compare with the minimum required viscosity for your bearing size and speed.
  4. If the operating viscosity is too low, step up one ISO grade.
  5. If the bearing runs at very high speed, step down one grade to reduce churning heat.

Frequently Asked Questions

What viscosity grease is used in electric motors?

Most motor greases use ISO VG 68 to 100 base oil at NLGI 2 consistency. This balances high speed and load capacity.

Can I use a thicker oil to protect a worn bearing?

A thicker oil may reduce noise temporarily, but it will not restore a damaged raceway. It also increases heat and drag. Replace the bearing instead.

Why does my oil look thinner after summer?

Oil viscosity drops as temperature rises. A VG 68 oil at 80 C may be as thin as VG 22. This is normal, but if it drops below the minimum, the bearing needs a higher viscosity grade or a cooler operating temperature.

Related Reading

Need Lubricant Recommendation?

MS Bearing can recommend the correct grease or oil viscosity for your bearing based on speed, load and temperature. Send us your operating conditions, and we will specify the lubricant grade and relubrication interval.