sales@cnprv.com

+86 15862366271 (WhatsApp/WeChat)

Relubrication Interval: When and How Much Grease to Add

MS Bearing WareHouse

Even the best grease degrades over time. Relubrication on schedule is the cheapest way to double or triple bearing life. This guide explains how to calculate the relubrication interval and how much grease to inject.

See also grease vs oil and NLGI consistency.

Why Relubricate?

Grease ages from three mechanisms: oxidation from heat, mechanical breakdown as the grease is worked, and contamination from dust and moisture. Once the base oil separates from the soap thickener, the bearing runs dry. Relubrication refreshes the oil film and flushes out degraded grease and wear particles.

Typical Relubrication Intervals

Bearing TypeTemperature 70 CTemperature 100 C
Deep groove ball bearing12,000 - 20,000 h4,000 - 8,000 h
Angular contact ball bearing10,000 - 15,000 h3,000 - 6,000 h
Cylindrical roller bearing8,000 - 12,000 h2,000 - 4,000 h
Tapered roller bearing6,000 - 10,000 h1,500 - 3,000 h
Spherical roller bearing4,000 - 8,000 h1,000 - 2,000 h

These values assume clean environment and normal load. Halve the interval for dirty environments, high vibration, or heavy shock load.

How Much Grease to Add

The standard relubrication quantity is:

G = 0.005 * D * B    (grams)

Where D = bearing outside diameter in mm, B = bearing width in mm.

Example: 6205 bearing (D = 52 mm, B = 15 mm): G = 0.005 * 52 * 15 = 3.9 grams.

Do not over-grease. Over-greasing causes churning heat, which is the second most common cause of motor bearing failure after contamination. Add the calculated amount, run the bearing for a few minutes, then remove the drain plug to let excess grease escape.

When to Relubricate Sealed Bearings

Double-sealed (2RS) bearings are greased for life at the factory. For normal industrial service, do not relubricate. If the application is especially dirty or hot, you can inject a small amount of fresh grease through a housing fitting, but expect the seals to bulge and possibly fail.

Signs It Is Time to Relubricate

  • Bearing temperature rises 5 to 10 C above normal
  • High-frequency noise increases
  • Old grease looks dry, crumbly or separated
  • Planned maintenance interval has elapsed

Frequently Asked Questions

Can I relubricate too often?

Yes. Over-greasing causes more heat than under-greasing. Follow the interval and the calculated quantity. If you must relubricate frequently, investigate the root cause (high temperature, contamination, wrong grease).

What happens if I never relubricate?

The grease oxidizes, the oil separates, and the bearing runs dry. Metal-to-metal contact begins within weeks or months of the grease failing, and the bearing spalls prematurely.

How do I know the grease is still good?

Take a small sample between your fingers. It should be smooth and uniform, not crumbly, oily-separated or discolored. If it looks like dry tar, relubricate immediately.

Related Reading

Need Relubrication Schedule?

MS Bearing can help you set a relubrication schedule for your equipment. Send us your bearing numbers, operating hours and temperature, and we will recommend the interval and grease quantity for each point.