Cranes and hoists combine slow speed, huge static load, shock loading from lifting, and frequent direction reversals. The bearings in these machines must survive years of abuse. This guide covers where bearings are used on a crane and how to select them.
See also tapered roller bearings.
Where Bearings Live on a Crane
Wire Rope Sheaves
Every wire rope passes over sheaves. The sheave bearing sees a huge static load from the rope tension, intermittent motion, and shock when the load is picked. Cylindrical roller or needle roller bearings are common, often sealed and relubricatable.
Hoist Drum
The drum that winds the wire rope runs on two heavy bearings. They see very high radial load and occasional rotation. Spherical roller bearings tolerate drum deflection and misalignment.
Hook Swivel
The hook rotates freely under load so the wire rope does not twist. A thrust bearing inside the hook carries the full lifted load. It is usually a thrust ball or tapered thrust bearing, greased for life.
Bridge and Trolley Wheels
Bridge end trucks and trolley wheels run on tapered roller or deep groove bearings, carrying the whole crane weight plus the lifted load.
Slew Ring (Turntable Bearing)
On slewing cranes (top-sleving tower cranes, mobile cranes), a large crossed roller or four-point contact ball bearing allows the upper structure to rotate. This is a precision gear-ring bearing, custom to the crane.
Why Crane Bearings Are Different
- High static load (the lifted weight sits on the bearing for hours)
- Shock load when a load is picked suddenly
- Frequent starts, stops and direction reversals
- Outdoor environment: rain, dust, temperature swings
- Failures have serious safety consequences
Selection Rules
- Use spherical roller bearings for long drums where deflection is expected
- Use sealed and relubricatable bearings for outdoor service
- Choose C3 or C4 clearance for heavy interference fits and outdoor temperature swings
- Size by static load rating C0, not dynamic C. The bearing mostly sits still.
Frequently Asked Questions
How often should I grease crane bearings?
Sheaves and drums every 50 operating hours, or monthly. Hook swivels every 6 months. Over-greasing blows out the seals, so pump slowly until fresh grease appears at the seal lips.
What happens if a sheave bearing fails?
The wire rope locks on the sheave, wears rapidly, and may jump the groove. Replace sheave bearings on schedule - they are cheap insurance against a dropped load.
Can I use a standard deep groove bearing on a crane wheel?
For very small jib cranes, yes. On industrial overhead cranes, tapered roller bearings carry the combined radial and thrust loads from wheel flange contact with the rail.
Related Reading
Need Crane Replacement Bearings?
MS Bearing supplies spherical roller, tapered roller and thrust bearings for overhead cranes, hoists and wire rope sheaves. Send us your crane model or bearing numbers, and we will confirm replacements for sheave, drum and hook positions.
