Food and pharmaceutical equipment faces a unique set of demands: daily washdown, chemical cleaners, strict hygiene standards, and zero tolerance for lubricant leakage. This guide covers bearing selection for hygienic applications.
See also seal selection.
Why Standard Bearings Fail in Washdown
Standard chrome steel bearings rust within days of daily washdown. The rubber seals degrade against caustic cleaners, and the grease washes out. Within months the bearing seizes. Food plants need bearings built for the environment.
Stainless Steel Bearings
Food-grade bearings use:
- AISI 440C stainless rings and balls - hardened to HRC 58-60, corrosion resistant
- 304 or 316 stainless housings - for pillow block units, no painted surfaces to chip
- Food-grade seals - silicone or EPDM, not NBR
Stainless bearings carry about 20 to 30 percent less dynamic load than 52100 chrome steel equivalents, so size up if load is heavy.
Food-Grade Lubrication
Any lubricant that could contact food must be NSF H1 registered (incidental food contact). Common food-grade greases:
- Aluminum complex thickener with white oil base
- Petroleum-based white grease (H1)
- Silicone-based for very high temperature
Never use industrial lithium grease on food equipment. If it leaks onto product, the batch is lost.
Hygienic Design Principles
- Smooth, crevice-free surfaces that can be hosed down
- No painted surfaces (paint chips contaminate product)
- Open-frame design where product cannot trap
- Sealed, for-life bearings to avoid grease zerk accumulation points
Typical Food Equipment Bearings
- Conveyor chains and rollers in packaging lines
- Mixers and blenders in food processing
- Bottling and filling machine bearings
- Pharma tablet press and granulator bearings
Frequently Asked Questions
Can I use chrome steel bearings in a dry food plant?
If there is no washdown, chrome steel with good seals works. But any food plant with cleaning will eventually get water on the bearings. Stainless is safer over the long term.
How often should I relubricate food-grade bearings?
Sealed for-life bearings need no relubrication. Greasable units need food-grade grease added every few months during washdown downtime. Over-greasing is worse than under-greasing in a food plant.
What does NSF H1 mean?
NSF H1 means the lubricant is acceptable for incidental contact with food. It is not toxic, and the small amount that might get into product will not cause harm. This is required in any food processing environment.
Related Reading
Need Food-Grade Bearings?
MS Bearing supplies 440C stainless steel bearings with food-grade H1 grease, plus stainless pillow block units for food and pharma equipment. Send us your equipment type and bearing numbers, and we will confirm hygienic replacements.
