If you open a modern VFD-driven motor and find a row of parallel grooves across the raceway, you are looking at electric fluting. It is a common and expensive failure mode on variable-frequency motors. This guide explains what causes it and how to prevent it.
See also other bearing failures.
What Is Electric Erosion?
Variable frequency drives induce a voltage on the motor shaft. The voltage builds up until it arcs through the bearing, discharging across the oil film. Each tiny spark melts a microscopic spot on the raceway. After thousands of discharges, the raceway develops a washboard pattern of grooves - this is fluting.
The bearing then begins to sound like a bag of marbles. Vibration increases dramatically. Eventually the raceway spalls.
How to Recognize It
- Parallel, regularly spaced grooves across the raceway, like a washboard
- Small melted pits on the rolling elements
- Bearing noise that sounds rough and rhythmic
- Common on the non-drive end bearing of VFD motors
Why It Happens
High-frequency PWM from the VFD induces a shaft voltage through electromagnetic coupling. The shaft has nowhere to go, so it discharges through the bearing to the housing. Ground brushes and shaft grounding rings are the standard fix.
Prevention Methods
- Shaft grounding ring - a braided copper ring at the shaft end provides a low-resistance path to ground, bypassing the bearing. This is the most cost-effective fix.
- Insulated bearings (INSOCOAT) - the outer ring is coated with aluminum oxide. Current cannot cross the bearing, so it must find another path. Use on the non-drive end.
- Hybrid ceramic bearings - silicon nitride balls are non-conductive, so current cannot pass. Used in high-end spindle and large motors.
- Shielded cables and VFD filters - reduce the voltage spikes at the source.
Frequently Asked Questions
Which bearing fails first, drive end or fan end?
Usually the non-drive (fan) end. It has less preload and the current takes the path of least resistance through it.
Can I regrind a fluted raceway?
No. Once fluting starts, the raceway surface is permanently deformed. Replace the bearing and add shaft grounding.
Do all VFD motors need insulated bearings?
Not all. Small motors under 15 kW often survive with just shaft grounding. Larger motors and critical applications should use insulated or hybrid bearings.
Related Reading
Need Insulated or Hybrid Bearings?
MS Bearing supplies standard deep groove, cylindrical and angular contact bearings with optional outer ring insulation (INSOCOAT equivalent) and hybrid ceramic balls. Send us your motor details, and we will recommend the correct anti-electric-erosion solution.
