Removing a bearing is as important as installing it. Pulling on the wrong ring, or using a jaw puller that digs into the raceway, can damage the shaft or housing. This guide covers correct disassembly methods.
See also installation methods.
Remove the Inner Ring (On the Shaft)
Because the inner ring is an interference fit on the shaft, pull on the inner ring - never on the outer ring or rolling elements.
Mechanical Puller
A two or three-jaw puller grips the inner ring face and pulls it straight off the shaft. Make sure the puller jaws contact only the inner ring. Protect the shaft end with a center point.
Hydraulic Nut
For large bearings on tapered seats or adapter sleeves, a hydraulic nut pulls the inner ring off precisely and safely. This is the standard method on mining and paper machine rolls.
Induction Heating
Heat the inner ring quickly with an induction heater to expand it, then slide it off the shaft. This works for inner rings that are heavily press-fitted. Do not heat the outer ring or rolling elements.
Remove the Outer Ring (From Housing)
Outer rings are usually press-fitted into the housing. Use a hook spanner or a bearing puller that pushes against the housing bore. For blind bores, use outer ring pullers that grab the ring from behind.
What If the Bearing Is Scrap Anyway?
If the bearing is already failed and you do not plan to reuse it, you can use more aggressive methods: heat it up, cut it off with a grinder (careful not to cut the shaft), or use a bearing splitter. Never damage the shaft or housing in the process.
Common Mistakes
- Pulling on the outer ring to remove an inner ring - transmits load through rolling elements
- Hammering on the shaft end - damages the shaft bearing seat
- Digging puller jaws into the raceway - scratches the new bearing seat
- Heating the whole bearing instead of just the ring you want to expand
Frequently Asked Questions
Can I reuse a bearing after disassembly?
Only if it is in good condition and was not running when removed. Inspect the raceway, clean it, and repack with fresh grease. For critical applications, replace with new.
How do I remove an outer ring from a blind bore?
Use outer ring pullers (also called internal pullers) that hook behind the ring. If no access exists, drill two small holes opposite each other in the housing and push the ring out with punches.
Do I need to replace the shaft after removing a bearing?
Only if the shaft seat is scored or worn. Measure the shaft diameter after removal. If it is within tolerance, reuse it.
Related Reading
Need Replacement Bearings?
MS Bearing supplies direct replacement bearings for all standard types. Send us the bearing number you removed, and we will confirm availability and factory-direct pricing for the replacement.
