sales@cnprv.com

+86 15862366271 (WhatsApp/WeChat)

Angular Contact Bearing Arrangements: DB, DF, DT Preload Explained

MS Bearing WareHouse
author admin 09 November, 2026

Angular contact ball bearings cannot carry combined radial and axial loads reliably as a single unit in both directions. They are almost always mounted in matched pairs. The arrangement (DB, DF, DT) and preload level decide stiffness, load sharing and direction capability.

DB: Back-to-Back (O arrangement)

In DB, the outer ring backs are on the outside and the inner rings face each other. The contact lines form an O shape diverging toward the outer side. DB sets have a large spread between the effective load centers, giving high moment stiffness—they resist tilting loads well. DB is the most common arrangement for machine tool shafts, pinions and bevel gear supports. It can carry radial load plus axial load in both directions and moments.

DF: Face-to-Face (X arrangement)

In DF, the wide faces of the outer rings are toward each other. The contact lines form an X converging toward the outer side. DF has a smaller load-center spread and lower moment stiffness than DB, but it is more forgiving of shaft misalignment and easier to adjust. DF is used where alignment is less perfect and where axial load acts mainly in one direction.

DT: Tandem (tandem arrangement)

In DT, both bearings face the same direction. All contact lines run parallel. DT can carry a very large axial load in one direction (the load is shared by two bearings in series) but cannot carry axial load in the opposite direction unless a second DT pair is added. DT is used for very high single-direction axial loads such as large gear drives and screw supports.

Preload Levels: GA, GB, GC

Matched angular contact sets are supplied with a light (GA), medium (GB) or heavy (GC) preload. Preload removes internal clearance, increases stiffness and reduces noise, but also generates heat. Too much preload causes overheating and short life.

PreloadUse
GA (light)Moderate speed, moderate stiffness, small motors, pumps
GB (medium)Machine tool spindles, high stiffness, moderate speed
GC (heavy)Heavy preload, very high stiffness, lower speed, precision axes

Contact Angle Matters

Angular contact bearings come in 15° (C), 25° (AC) and 40° (B) contact angles. Larger angle means higher axial capacity but lower speed. 15° is for high speed light axial; 25° general; 40° for heavy axial. See Angular Contact Ball Bearings guide.

Which Arrangement to Choose

Pick DB for moment stiffness and general machine tool work. Pick DF when mounting errors exist and moment stiffness is less critical. Pick DT when a single-direction axial load is very large and needs two bearings in series. For combined bi-directional axial and moment loads, DB remains the default.

FAQ

Q: Can I use two random 7205 bearings as a pair?
A: Not for precision. Matched sets (DB/DF/DT) are selected and ground so preload and load sharing are controlled. Random bearings will have uneven preload.

Q: Is DB stiffer than DF?
A: Yes, DB has higher moment stiffness because the load centers are farther apart.

Q: What preload for a spindle running 10,000 rpm?
A: Usually GA (light) or GB. Heavy GC preload generates too much heat at high speed.

Q: Can DT carry axial load both ways?
A: No. DT carries axial in one direction only. Add another DT pair opposite for bi-directional.

Related Reading

Need matched angular contact sets for a spindle or pinion? Tell us your contact angle, bore and required preload—we supply DB/DF/DT sets in 70xx and 72xx series.