sales@cnprv.com

+86 15862366271 (WhatsApp/WeChat)

Shaft and Housing Fits: g6, h6, k6, m6 Tolerance Chart

MS Bearing WareHouse
author admin 09 November, 2026

The fit between bearing rings and shaft/housing decides whether a ring creeps, runs true and reaches its rated life. The most common mistake in bearing installation is applying an interference fit to the ring that should rotate, or a loose fit to the ring that should be fixed. This guide lists the standard ISO fits used for rolling bearings.

Which Ring Should Be Interfered?

The golden rule: the ring that rotates should be interference-fit; the stationary ring can be transition or clearance fit. In the vast majority of applications the inner ring rotates with the shaft, so the shaft is interference fit and the housing bore is transition fit. If the outer ring rotates (for example a pulley rotating on a stationary shaft), the logic reverses.

Shaft Fits for Inner Ring Rotation

Shaft toleranceFit typeTypical use
g6Clearance (loose)Inner ring floats, idler pulleys, needle roller, some thrust bearings
h6Transition (slight clearance)Light loads, adjustable bearing locations, small bearings
j6 / js6TransitionNormal loads, fixed position bearing on inner ring
k6Light interferenceNormal radial loads, most deep groove ball bearing applications
m6Medium interferenceHeavy loads, shock loads, spherical roller bearings
n6Heavy interferenceHeavy shock, large size, straight-bore roller bearings under impact
p6 / r6Very heavy interferenceLarge bearings, constant heavy radial load

Housing Bore Fits for Stationary Outer Ring

Housing toleranceFit typeTypical use
H7ClearanceNormal outer ring, allows slight axial movement (floating bearing)
J7 / JS7TransitionLighter loads, easy installation
K7Light interferenceFixed (locating) side bearing, moderate loads
M7 / N7InterferenceHeavy shock, precision locating
P7Heavy interferenceOuter ring rotates (pulley applications)

Fit Selection by Load Direction

For normal radial load with inner ring rotating, choose k6 or m6 on the shaft and H7 or J7 in the housing. For heavy shock loads (vibrating screens, crushers), step up to m6/n6 on the shaft. For light or reversed loads, use j6 or h6 to allow easier mounting.

When the outer ring rotates (such as a wheel hub or sheave), the outer ring must be interference in the housing (P7 or N7) and the inner ring can be transition on the shaft (j6). This prevents creep on the rotating ring.

Fit and Clearance Interact

An interference fit on the inner ring expands the ring and reduces internal clearance. This is why most bearings run C3 rather than C0: the fit eats clearance, and C3 leaves a safe residual. If you fit n6 or p6, consider C4 instead of C3 to avoid running clearance disappearing. See internal clearance selection.

Tolerances for Tolerance-Class Bearings

P5, P4 and P2 precision bearings require correspondingly tighter shaft and housing tolerances. A P4 bearing should run on a shaft ground to IT3-IT4 and a housing bore bored to IT4. Using P4 on a h6 shaft wastes the precision. See L10 life calculation for more on selection.

FAQ

Q: Should the inner ring be press fit?
A: Yes, when the inner ring rotates with the shaft. Use k6 or m6 for normal industry.

Q: Can I mount a bearing on a h6 shaft?
A: Yes for light loads and fixed-side arrangements. h6 leaves a slight clearance and lets you slide the bearing on easily, but under load it can creep if used on a rotating ring with heavy load.

Q: What housing tolerance for a floating bearing?
A: H7. The outer ring must be able to slide axially in the bore to accommodate shaft expansion.

Related Reading

Need a fit recommendation for your shaft and housing? Send us the bearing bore, load type and operating temperature—we will recommend ISO fits and clearance class.