Bearing lubrication is more than grease vs oil. Industrial systems range from simple grease packs to oil-air and oil-mist delivery. The choice decides maximum speed, temperature capability, sealing needs and maintenance burden.
Grease Lubrication
Grease is a base oil thickened with soap. It stays in place, seals out contamination and needs no circulation system. It works for 90% of general bearings up to moderate speed and temperature. See grease vs oil. Relubrication intervals are governed by speed and temperature (interval guide).
Oil Bath and Splash Lubrication
In oil bath, the lowest bearing rollers dip into an oil sump. It is simple and reliable for low-to-moderate speed gearboxes and pillow blocks. At high speed, churning causes heat, so oil level must reach only the center of the lowest rolling element.
Circulating Oil
Circulating oil delivers lubrication and cooling. A pump sends filtered oil to each bearing and returns it to a tank, often with a cooler. Used in high-temperature gearboxes and large turbomachinery. See oil lubrication systems.
Oil Mist
Oil-mist systems atomize oil into dry air and deliver a continuous mist to the bearing. They reduce friction and heat, work at high speed and provide a slight positive pressure that keeps contamination out. They require an oil-mist generator and carefully sized nozzles. Oil mist is common in paper machines and high-speed spindles.
Oil-Air (Minimum Quantity)
Oil-air delivers small oil pulses in a continuous air stream, but unlike oil mist the oil is not atomized—it arrives as a slug. It is cleaner than oil mist, suits food and clean environments, and is used in machine tool spindles and rail traction motors. Oil-air uses less oil than oil mist.
Selection Guide
| Condition | Best method |
|---|---|
| General motor, fan, pump | Grease |
| Gearbox, moderate speed | Oil bath / splash |
| High temperature, heavy load | Circulating oil |
| Very high speed spindle | Oil-air or oil mist |
| Dirty environment | Grease with contact seal |
FAQ
Q: Is oil-air the same as oil mist?
A: No. Oil mist atomizes oil into the air stream; oil-air carries oil slugs in compressed air without atomizing.
Q: Can I convert a greased bearing to oil mist?
A: Usually yes, but remove seals and shields and confirm cage compatibility.
Related Reading
- Grease vs Oil Lubrication
- Oil Lubrication Systems: Splash, Circulation, Jet
- Lubricant Viscosity Selection
Designing a lubrication system for a high-speed line? Tell us speed, temperature and environment—we will recommend grease, oil, oil mist or oil-air.
