sales@cnprv.com

+86 15862366271 (WhatsApp/WeChat)

How Much Grease to Fill in a Bearing? Correct Quantity Formula

MS Bearing WareHouse

Packing a bearing full of grease is not the safe choice. Over-greasing generates churning heat, especially at high speed. Under-greasing leads to metal-to-metal contact. The correct fill depends on bearing size, housing design and speed.

Initial Fill for Open Bearings in a Housing

For a standard bearing housing, fill the bearing itself completely with grease, then fill 30% to 50% of the free housing space. This leaves room for grease expansion and avoids churning. At low speeds (below 50% of the speed limit), you may fill 60–90% of the housing. At high speeds, reduce to 20–30%.

Rule of Thumb Formula

A common approximate formula for initial grease quantity in grams:

G ≈ 0.005 × D × B

where D is outer diameter in mm and B is bearing width in mm. This gives a starting point; the housing volume rule above still applies.

Sealed and Shielded Bearings

Sealed bearings (2RS, ZZ) are greased at the factory with roughly 25–35% of free space. Do not wash them out and do not add extra grease. They are designed for life-long lubrication without relubrication. See grease vs oil.

Relubrication Quantity

When greasing through a nipple, add a small amount at a time while the bearing runs. A typical rule is to add roughly 1/4 to 1/3 of the initial fill every relubrication interval. Pumping too much at once blows seals and overheats. For relubrication intervals, see relubrication interval guide.

Why Over-Greasing Hurts

Grease that churns inside a rotating bearing heats up, oxidizes and hardens. The drag torque increases, the temperature climbs, and the grease loses its base oil. High-speed motors and fans often run hotter after a re-greasing because maintenance staff packed the housing too full. At speeds above 70% of the limit, use the low-fill figure.

FAQ

Q: Should I fill the bearing and housing completely?
A: No. Fill the bearing fully, but only 30–50% of the housing. More is not better.

Q: Can I over-grease a sealed bearing?
A: You cannot add grease to a sealed bearing through a nipple. If the housing has a drain plug, open it during re-greasing to push out old grease.

Q: What grease quantity for a pillow block?
A: Standard pillow blocks come pre-greased. Re-grease with 2–5 pumps of a grease gun depending on size, while the unit runs.

Related Reading

Setting up a relubrication schedule? Tell us bearing size and speed—we will recommend initial fill and interval.